Using Dial-Up

How to setup the Dial-Up Server

Receive Calls

To allow users to access Capturix VideoSpy remote administration, using a Browser over a phone line you need to activate the Windows Dial-Up Server, this service is available in Windows 98 or higher and its available for Windows 95 on Microsoft site.

Using Windows 9x:

Windows 95

1. Double-click My Computer .
2. If there is a Dial-Up Networking folder in My Computer, Dial-Up Networking is already installed. Skip to the "To install the Dial-Up Networking Server Component" section. If there is no Dial-Up Networking folder, continue with these steps.
3. Click Start , point to Settings , click Control Panel , and then double-click the Add/Remove Programs icon.
4. On the Windows Setup tab, click Communications in the Components box, and then click Details .
5. Click to select the Dial-Up Networking check box, and then click OK .
6. Click OK .

Windows 98/Me

1. Click Start , point to Settings , click Control Panel , and then double-click the Add/Remove Programs icon.
2. On the Windows Setup tab, double-click Communications .
3. Click to select the Dial-Up Networking Server or Dial-Up Server check box, and then click OK .
   

To configure a computer to be a Dial-Up Networking server, follow these steps:

1. In My Computer , double-click the Dial-Up Networking folder.
2. On the Connections menu, click Dial-Up Server .
3. Click Allow Caller Access .
4. If you want to require remote users to enter a password when they connect to your computer by using Dial-Up Networking, click Change Password , and then type the password you want to use.
5. Advanced Settings: Type of Connection: PPP: Windows.....
6. Click OK

Now your computer is available for remote access through a phone line:

1. In Capturix VideoSpy , click on Tray Menu, Remote Administration.
2. Enable Web Administration .
3. Your access address will be the Web Server address or the computer name:
   http://192.168.10.33:1001/
   http://<computername>:<port>/

Using Windows 2000/XP:

To make an incoming network connection

1. Open Network Connections.
2. Under Network Tasks, click Create a new connection, and then click Next.
3. Click Set up an advanced connection, and then click Next.
4. Click Accept incoming connections, click Next, and then follow the instructions in the New Connection Wizard.

Notes

1. To open Network Connections, click Start, point to Settings, click Control Panel, and then double-click Network Connections.
2. You must be logged on as a computer administrator to complete this procedure.
3. If you make another incoming network connection, and you use the New Connection Wizard again, the existing incoming network connection is reconfigured.
4. If your incoming connection and Fax Service have problems working together (for example, you cannot receive incoming connection calls on a device enabled for Fax receive), the modem may not support adaptive answer. Check your modem documentation to verify that you need to disable Fax receive for that device to accept incoming connections.
5. Incoming connections are only used for dial-up, VPN, or direct connection clients.
6. Select TCP/IP Protocol

Now your computer is available for remote access through a phone line:

1. In Capturix VideoSpy , click on Tray Menu, Remote Administration.
2. Enable Web Administration .
3. Your access address will be the Web Server address or the computer name:
   http://192.168.10.33:1001/
   http://<computername>:<port>/