How to Realize Remote Access Within WAN?

To realize remote access within WAN is a little more complicated than to do so within LAN.

First of all the computer of monitoring terminal should be connected to Internet. CamGuard Security System (4 Channels) supports a variety of Internet connection modes, including dialup and small-size LAN through routers.

To realize remote access within WAN, the remote terminal should be enabled to locate the monitoring terminal in the WAN. For this reason, a remote service account should be applied first, through which the monitoring terminal can be located. Remote service account can be registered in Remote Options.

When finishing registration of the account, select "Enable Remote Service Account", fill in the account and password applied, and click Apply.

When the following information is displayed in status bar, it means that the Remote Options has been completed successfully. If anything abnormal happened, please refer to "Local Web service fails to establish interception on 808 port" and "Unable to connect to remote service server"

When Remote Options is completed successfully, the next step is to turn on the Local Monitor terminal and enable remote monitoring service. The procedure is the same as that of realizing access within LAN.

After the above steps are finished, the monitoring terminal can now provide remote monitoring service normally. The following is about how to access remote terminal.

Setting interface of the remote terminal is as follows:

Select the access mode as "Remote access". Fill in the remote service account used by the monitoring terminal in remote service account and the password is the access permission password set in Remote Monitor Options . When setting is finished, click OK to connect to the monitoring terminal for viewing locale. After the initial setting, the connection will be automatically made when the remote monitoring window is opened for the second time.